Power UNITS FOR LIFT TABLE 1
Basic Description
This electrical power unit is created exclusively to the tiny lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has become broadly utilised inside the marketplace of logistic units including minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed from the solenoid valve using the speed managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
General Description
This electrical power unit is developed solely for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve along with the speed managed through the adjustable needle valve. When the lift rises to a high positoin, but the energy provide is cut, the lowering movement is managed by the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This energy unit is developed solely for that substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve along with the speed managed by a stress compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This electrical power unit is developed solely for that substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the velocity managed from the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is minimize, the reducing motion is managed from the manual override perform.
Exclusive Notes
one. This power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned just before set up of the electrical power unit.
3. Viscosity in the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is advisable.
4. Oil modifying is needed following the first one hundred operation hours,afterwards the moment every 3000 hours.
5. The power unit proven is intended to be mounted vertically.