C Style Flex-Flex Couplings
The C Style coupling includes two flex hubs, one sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Variety Flex-Rigid Couplings
The CFR Style coupling consist of one particular flex hub, one particular rigid hub, a single sleeve, 1 accessory kit consisting of seals and snap rings.
Capabilities
Easy and low-cost form of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Readily available as vertical and horizontal couplings
Wide selection of special variations for instance full-flex, flex-rigid mill motor
Typical configurations can be found of your shelf
Ordering Information and facts
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Info
Puller Holes are regular on sizes 4 by twelve.
Puller Holes are available for sizes 7/8 by means of three.5 at an extra charge.
The BSE (distance Among Shaft Ends) might fluctuate between G and G1.
Interference bores with no set screws are standard unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, talk to Engineering Area.
More substantial sizes are available, please check with Technical Assistance.